|
3115-90C
This Combination Lavatory/Toilet Fixture is designed for high
security areas with an accessible pipe chase. Fixtures are
fabricated using 14-gauge type 304 stainless steel,
seamlessly welded to form a one piece, vandal resistant
unit. Internal piping is stainless steel. Exposed surfaces are
polished to a satin finish, except for the integral seat which
is polished to a bright mirror finish.
PERFORMANCE
Metcraft bowls and assemblies are designed to withstand
5000 lb. (22kN) loading without permanent deflection and
damage. They meet or exceed ASME 12.19.6M for hydraulic
performance and ASME 112.19.2M for physical dimensions.
The trap will pass a 2 5/8" (67mm) dia. ball. A minimum 1"
(25mm) supply providing 25psi (172kPa) flushing pressure is
required.
WATER CONSUMPTION
With a water saver flush valve - 3.5 gpf (13 liters)
With a low consumption flush valve - 1.6 gpf (6 liters)
STANDARD FEATURES
• Floor mounted cabinet, wall outlet waste.
• Oval lavatory basin with fast drain, air circulating self
draining soap dish, and 4" (102mm) high backsplash.
• Elbow sink waste with air vent and 11/4" (32mm) OD
plain end extended 4" (102mm) past back of fixture
for slip type connection.
• Plated steel concealed anchor rods and fasteners.
• Back supply connection 11/2" (38mm) FIPT.
• Integral elongated seat.
• Self draining flushing rim.
• Blowout flushing action.
• 3" (76mm) OD toilet waste tube with plain end extended 4"
(102mm) past back of fixture for NH type connection.
• Fully enclosed trap.
INSTALLATION
An accessible pipe chase is required. Six 1/2" (13mm) dia.
plated steel anchor rods screw into sockets on back of the
fixture. Anchor rods pass through the wall and are secured
with washer lugs and hex nuts on the chase side of the wall.
No exposed fasteners are used. The installer must provide
wall openings for anchor rods, piping, and valve operators
per rough-in drawings provided by Metcraft. Valves are
installed in the pipe chase.
NOTE: A security frame (wall sleeve) is recommended
when installed on a new block (CMU) or poured concrete
wall. A security frame is not appropriate for hollow wall
construction.
|
